 |
 |
Introduction
Thank you for buying an 86″ Classical Pilates Reformer. This manual will show you how to build the Reformer. Please ensure you read it fully before unpacking and assembling the equipment.
What’s Included?
- 1x Reformer Frame
- 1x Reformer Carraige
- 1x Sitting Box
- 2x Anti Slip Pads
- 1x Maple Pole
- 1x Parts Box:
- 1x Tool Kit
- 2x Foot Straps
- 2x Leather Straps
- 2x Handles
- 4x Springs
Assembly
Unpacking The Reformer
Please unpack all of the equipment in a clear, clean & dry environment on a level floor surface, using two people to remove the large components. Remove the plastic packaging from the Reformer frame, stopper blocks, and spring bar.
Setting the Foot Bar
Lift the foot bar and set it in its upright position.
Inserting the Carriage
Remove the packaging from the Carriage and carefully place it in the runners of the Reformer frame, using two people to hold the Carriage.
Attaching the Springs
Attach all of the springs to the underside of the carriage. Ensure they sit inside the support bar.
Attaching the Foot Strap
Clip both foot straps to the eyelets under the foot bar.
Threading the Straps
Feed the looped end of the leather strap through the pulley wheel from the bottom, then clip the handle to the D-Ring on the leather strap.
Optional Jump Board
Remove the jump board bracket from the box. Position the bracket under the Foot Bar so that the 4 holes line up with the 4 in the Reformer frame. Use the 4 bolts and the 6mm Allen Key supplied to attach. The Jump Board is now ready to be added into the bracket.
Warranty Information
Warranty information for the 86″ Classical Pilates Reformer is available at Warranty & Maintenance.
