Classical Full Pilates Cadillac

Introduction

Thank you for buying an Classical Full Pilates Cadillac. This manual will show you how to build the Cadillac. Please ensure you read it fully before unpacking and assembling the equipment.

What’s Included?

‘Classic Cadillac — Base’ Box:

• 1 x Base Frame
• Springs Box
• 11 Springs (5 pairs of different strengths and sizes. 1 single spring with tear drop eyelet)
• 2 x Foot Straps
• 1 x Belly Strap
• 1 x Trapeze Strap
• 2 x Fluffys
• Parts box
  • 2 x handles
  • 1 x swing through bar
  • 1 x trapeze seat

‘Classic Cadillac — Frame’ Box:

• 4 x Upright Poles
• 1 x Halo Frame
• 1 x Roll Down Bar
• Accessories Box
  • 2 x Allen Key
  • 1 x Multi Tool
  • 1 x Long Safety Chain
  • 1 x Short Safety Chain
  • 2 x Screw in Eyelets
  • 16 x Clips
  • 2 x Washers

Assembly

Unpacking The Cadillac

Please unpack all of the equipment from both boxes in a clear, clean & dry environment on a level floor surface, using two people to remove the large components.

Inserting The Upright Poles

Out of the four Upright Poles, identify the two with a single eyelet and insert them both at the end of the base frame which has fixed eyelets. Insert the other two Upright Poles (which have two eyelets) at the opposite end of the base frame. The lowest eyelet should be facing inwards.

Attaching the Swing Through Bar

Insert the hollow rod through the holes in the wooden frame. Add plastic washers to both ends then hold the Swing Through Bar in position and feed the threaded rod from the outside of the upright pole, through the hollow rod, then through the second upright pole. Use the nut to secure and tighten using the multitool.

Attaching the Halo Frame

With two people, place the Halo Frame on top of the Upright Poles, making sure that the end with three eyelets is at the end of the Cadillac with the Swing Through Bar.

Attaching the Trapeze

Clip the Trapeze strap onto the underside eyelets of the Halo Frame. Attach the springs with the plastic covers to the Trapeze seat. Attach the other end of the spring to the horizontal adjustable bar on the Halo Frame.

Attaching Springs

Attach all the other springs to the Roll Down Bar, Push Through Bar, handles, and straps. Attach to the frame depending on where you require them.

Final Assembly

Loop the fluffy straps around the Halo Frame. Place a washer on each of the screw in eyelets and then attach them in the holes on the Base Frame – tightening each with the multitool. Finally, using the allen key, go around the frame and tighten all grub screws — there are four at the base of each Upright Pole and three on each top corner of the Halo Frame.

Warranty Information

Warranty information for the Classical Full Pilates Cadillac is available at Warranty & Maintenance.